Universal Input Signal Converter DAT2115 PC Programmable.
GENERAL DESCRIPTION
The universal Converter DAT2115 is a Din Rail mount temperature/signal Converter with PC programmability. The input can be thermocouples, RTD, mA, V, mV, resistance and potentiometer. The DAT2115 will linearize the temperature input and provide a 4-20mA or voltage output signal.
The DAT2115 is accurate to 0.1% full scale and has less than 0.01%/'f thermal drift.
The DAT2115 is programmable by PC based software which has been developed by DATEXEL to be user friendly.
For resistance and RTD's sensors it is possible to program the cable compensation for 3 or 4 wires.
It is possible to set the minimum and maximum values of the input and output ranges in any point of the scale, keeping the minimum span shown in the table below. Also high burn out alarm or low burn out alarm is selectable.
The DAT2115 is in compliance with the standard 89/336/CEE on the Electromagnetic Compatibility.
The DAT2115 is housed in a plastic enclosure of 12.5 mm thickness suitable for DIN rail mounting in compliance with EN-50022 and EN-50035 standards.
The DAT2115 is able to measure and linearize the standard thermocouples with internal cold junction compensation.
Suitable for the following thermocouples.
K Type Thermocouples
J Type Thermocouples
S Type Thermocouples
R Type Thermocouples
B Type Thermocouples
E Type Thermocouples
T Type Thermocouples
N Type Thermocouples
Suitable for the following RTD.
Pt100
Pt1000
Ni100
Ni1000
